We and our partners use cookies to Store and/or access information on a device. We and our partners use data for Personalised ads and content, ad and content measurement, audience insights and product development. Start at the wheel well where you have removed the wheel. Put the socket and the extension behind the cables and feel your way in to the top bolt of the starter motor. When the socket is securely on the bolt, use a ratchet to unscrew the top bolt. Figure 3. Remove the top bolt using an extension and a swivel (red arrow). Consider to support my channel and all the hard work put into it at http://www.patreon.com/LMAutoRepairsThank youHiThis car came to me in limp mode, the engi What is the drivetrain, Citroen C3 I (Phase I, 2002) Hatchback 2003 1.4 HDi 16V (90 Hp)? Front wheel drive. Internal Combustion engine. The Internal combustion engine (ICE) drives the front wheels of the vehicle. How long is this vehicle, 2003 Citroen C3 Hatchback? 3850 mm 151.57 in. How wide is the vehicle, 2003 Citroen C3 Hatchback? 1667 mm To remove the starter motor, disconnect the battery first. Take a picture, if possible, so that the new starter can be put back in place the same as the old one was. Disconnect the wires and When the Berlingo was first shown at the Mondial de l'Automobile (Paris Motor Show) in 1996, a set of three concept cars was also presented: Berlingo Coupé de Plage; Berlingo Berline Bulle; Berlingo Grand Large; The Berline Bulle concept was a roomy small car, that could be considered as a precursor for the C3. Only one of these concepts was The fault code P1351 comes back straight away after it is cleared. Pins 7,6,2,3, all have 12.6v from the wiring harness relay, so I think I pulled out the glow plugs for nothing, as I thought pins 7,6,2,1 were the glow plugs. The actuator test for the relay works (I can hear clicking). Can anyone help with a wiring diagram for the relay harness Starter is mounted on passenger side of the bell-housing. Remove 1 end of support bar bolted on bottom side of frame and swing it out of the way. Remove the starter's 2 mounting bolts. Reposition solonoid posts to face you. Remove these cables.-----Car cable & OBD Connector It is a C3. with the 1.4 HDI engine, and more and more frequently, there just seems to be no power at low revs. It is as if the Turbo has dissapeared. Then as the revs rise (normally about 2000 to 2500 rpm), the turbo comes in with a wallop. I am assuming, there is a sensor gone a bit amiss, but the engine management light does not come on, so 2R9SaO.

citroen c3 1.4 hdi starter motor removal